Marshmallow Shooter

I was asked about the marshmallow shooter, so if you're dying to make your own, these are the instructions.

2 caps for 1/2" PVC
2 t joints for 1/2" PVC
2 - 90 degree joints for 1/2" PVC

1/2" (internal) pvc cut into (10' pole makes 4 marshmallow shooters)

• 5 three inch sections
• 1 one inch section (you can make it longer and just do three six inch sections if you like)
  
• 1 seven-to-whatever inch section

In the following schematic -the marshmallow goes in the top 3" section (not in the end of the barrel)

LIPS & MM GO HERE >	3 Inch	90 Degree
		1 Inch
90 Degree	3 Inch	T Joint	3 Inch	T Joint	7 inch or longer section
3 Inch				3 Inch
cap				cap

Don't glue anything. You want to be able to remove licked marshmallows that get stuck, or jammed marshmallows resulting from five year olds overloading the shooter. Use spraypaint or tape as necessary to decorate. Mini marshmallows may be white, multicolored or chocolate. Eye protection is recommended.